This helper spring kit is designed to keep the primary coilover spring seated when the suspension is unloaded at full droop.
When using a stiff linear style coilover spring, you may run into scenarios that unload the spring when you droop the suspension. These scenarios are not the end of the world but the proper way to run a spring is to have tension through the full travel range when unloading or drooping the suspension fully.
This kit is made from the highest
quality components available and comes with everything you need to add helper springs to your current 2.5" coilover spring configuration:
-(2) 7" Tall Springs with 10lbs/in Spring Rate
-(2) Billet Aluminum Slide Adapters
*Works with 2.5" coilover style spring configurations ONLY.
*The spring and adapater is approximately 1.50" thick, so you will need to move the height adjuster accordingly by that amount to compensate
NOTE: THIS KIT MUST BE INSTALLED BETWEEN THE PRIMARY SPRING AND THE HEIGHT ADJUSTING PERCH
